Coated Abrasive Belt MSDS Sheet

MSDS

Coated Abrasive Belts

Section I

Manufacturer's Name: Weiler Corporation
Address: One Weiler Drive, Cresco, PA 18326
Emergency Telephone Number: (570) 595-7495
Telephone Number for Information: (570) 595-7495
Date prepared: January 25, 2006
Name of preparer: Frank Hettes

Section II - Hazardous Ingredients / Identity Information

None by WHMIS criteria

Section III - Physical / Chemical Characteristics

Boiling Point: **N/A
Vapor Pressure (mm Hg.): **N/A
Vapor Density (AIR=1): **N/A
Solubility in Water: Insoluble
Specific Gravity (H₂O=1): **N/A
Melting Point: **N/A
Evaporation Rate (Butyl Acetate=1): **N/A
Appearance and Odor: Fabric coated with abrasive media

Section IV - Fire and Explosion Hazard Data

Flash Point (method used): **N/A
Flammable Limits: **N/A LEL: **N/A UEL: **N/A
Extinguishing Media: Treat for surrounding material
Special Fire Fighting Procedures: None known to us at this time
Unusual Fire and Explosion Hazards: None known to us at this time

Section V - Reactivity Data

Stability: Stable
Conditions to avoid: **N/A
Incompatibility (Materials to Avoid): None known to us at this time
Hazardous Decomposition or Byproducts: **N/A
Hazardous Polymerization: Will not occur

Section VI - Health Hazard Data

Route of Entry	Toxicological Properties	First Aid and
Inhalation (of dust)	Acute: Can cause nose, throat and respiratory tract irritation and coughing. Chronic: Prolonged exposure can cause respiratory tract and eye irritation problems.	Remove to fresh air, if symptoms persist, call a doctor.
Ingestion	-	Do not induce vomiting: Rinse mouth with water, then drink one glass of water. Contact a doctor immediately. Never give anything by mouth if victim is unconscious, is rapidly losing consciousness, or is convulsing.
Irritancy	Non hazardous by WHMIS criteria.	Skin contact: Wash with soap and water. Call a doctor if irritation develops.
Eye	Acute: Contact may cause mild irritation due to abrasive nature of the product.	Flush with water for 15 minutes; call a doctor if irritation develops.
Respiratory Tract Sensitization	Insufficient data available.	-
Carcinogenicity	Non hazardous by WHMIA criteria.	-
Teratogenicity	Insufficient data available.	-
Reproduction Mutagenicity	Insufficient data available.	-
Synergistic Materials	Not available.

Section VII - Precautions For Safe Handling And Use

Steps to be taken in case material is released or spilled: Before attempting clean-up,
refer to hazard data given above.
Waste disposal method: Review federal, provincial and local government requirements
prior to disposal.
Precautions to be taken in handling and storing: Store in a cool, dry, well-ventilated area.
Other Precautions: None.

Section VIII - Control Measures

Respiratory protection (specify type): Use dust mask fitted with dust filters.
Ventilation:
  Local Exhaust: For dusts, mists or fumes
  Mechanical (General):
  Special:
  Other:
Protective gloves: Not normally required; however, helpful in avoiding unnecessary contact.
Eye protection: Dust goggles recommended.
Other protective clothing or equipment: As required by employer code.
Work/Hygienic Practices:

**N/A = Not Applicable

MSDS Coated Abrasive Belts

MSDS

Coated Abrasive Belts