MSDS

Flap Wheels

Section I

Manufacturer's Name: Weiler Corporation
Address: One Weiler Drive, Cresco, PA 18326
Emergency Telephone Number: (570) 595-7495
Telephone Number for Information: (570) 595-7495
Date prepared: January 25, 2006
Name of preparer: Frank Hettes

Section II - Hazardous Ingredients / Identity Information

Hub: The hub is an "article" and does not release or result in exposure to a hazardous chemical
  under normal conditions of use.
Abrasive Material: Fastcut resin cloth A (180 & C) x 875 F
  Specific Chemical Identity: Cryolite (Na1AIF6)
  OSHA PEL: 15mg/M3

Section III - Physical / Chemical Characteristics

Boiling Point: **N/A
Vapor Pressure (mm Hg.): **N/A
Vapor Density (AIR=1): **N/A
Solubility in Water: Not known
Specific Gravity (H2O=1): **N/A
Melting Point: **N/A
Evaporation Rate (Butyl Acetate=1): **N/A
Appearance and Odor: Solid

Section IV - Fire and Explosion Hazard Data

Flash Point (method used): Not known
Flammable Limits: Not known
Extinguishing Media: Water, Carbon dioxide, Foam, Dry Chemical
Special Fire Fighting Procedures: None
Unusual Fire and Explosion Hazards: None

Section V - Reactivity Data

Stability: Stable
Conditions to avoid: **N/A
Incompatibility (Materials to Avoid): **N/A
Hazardous Decomposition or Byproducts: **N/A
Hazardous Polymerization: Will not occur

Section VI - Health Hazard Data

Health hazards (Acute and chronic): During use dust - fluoride (as F) - 2.5 mg/m3, inert or
  nuisance dust; respirable fraction - 5 mg/m3. (Federal OSHA permissable exposure limit)
Carcinogenicity: Not known
Signs and symptoms of exposure: **N/A
Medical conditions generally aggravated by exposure: Not known
Emergency and First Aid procedures:
  Inhalation - provide fresh air
  Eye - flush with plenty of water, mechanical irritations only
  Skin - may cause abrasions; obtain medical assistance if needed

Section VII - Precautions For Safe Handling And Use

Steps to be taken in case material is released or spilled: No special procedures
Waste disposal method: No special procedures
Precautions to be taken in handling and storing: Normal precautions should be taken for 
  nuisance dust and particulates generated during grinding which will be principally from the 
  workpiece rather than the product.
Other Precautions: Utilize approved respiratory protection for nuisance dust.

Section VIII - Control Measures

Respiratory protection (specify type):
Ventilation: Utilize local exhaust to keep airborne concentration below limits.
  Local Exhaust:
  Mechanical (General):
  Special:
  Other:
Protective gloves: Recommended when grinding
Eye protection: Face shield or safety goggles when grinding
Other protective clothing or equipment: Safety glasses and protective clothing must be 
  worn when operating power brushes
Work/Hygienic Practices: **N/A

**N/A = Not Applicable

Weiler Corporation Home
About Us | Products | Where To Buy | Solutions | Resources | Vortec Pro | Site Map

E-mail: info@weilercorp.com | Phone: 570-595-7495 or 800-835-9999


All Rights Reserved, Copyright © Weiler Corporation 1998-2008