Resin Fiber Discs Material Safety Data
Sheet (MSDS)
Section I
Manufacturer's Name: Weiler Corporation
Address: One Weiler Drive, Cresco, PA 18326
Emergency Telephone Number: (570) 595-7495
Telephone Number for Information: (570) 595-7495
Date prepared: January 25, 2009
Name of preparer: Frank J. Hettes
Section II - Hazardous Ingredients / Identity Information
Hazardous Components,
(Specific Chemical Identity, Common Name(s)
CAS#
OSHA PEL
*REG.
(Y/N)
ACGIH
TL
Carcinogen
(Y/N)
% (optional)
Aluminum Oxide
(Al2O3) (Alpha Alumina)
1349-28-1
15mg/m3
Y
10 mg/m3
N
-
Zirconia Alumina
(ZrO2) (Zirconium Oxide)
1314-23-4
5mg/m3
Y
5mg/m3
N
-
Cubitron
(Ceramic Aluminum Oxide)
ND
ND
ND
ND
N
-
Sodium Aluminum Fluoride (Na3AIF6) (Cryolite)
15096-52-3
-
Y
2-5mg/m3
N
-
Section III - Physical / Chemical Characteristics Boiling Point: **N/A
Vapor Pressure (mm Hg.): **N/A
Vapor Density (AIR=1): **N/A
Solubility in Water: **N/A
Solubility in Alcohol: **N/A
Specific Gravity (H2O=1): **N/A
Melting Point: **N/A
Evaporation Rate (Butyl Acetate=1): **N/A
Appearance and Odor: Fiber coated with an abrasive material
Section IV - Fire and Explosion Hazard Data Flash Point (method used): **N/A
Flammable Limits: LEL: **N/A UEL: **N/A
Extinguishing Media: **N/A
Special Fire Fighting Procedures: Fiber and resin material will burn and decompose,
use respiratory protection.
Unusual Fire and Explosion Hazards: None
Section V - Reactivity Data Stability: Stable
Conditions to avoid: **N/A
Incompatibility (Materials to Avoid): **N/A
Hazardous Decomposition or Byproducts: During use, dust and decomposing resin fumes are generated. Note: The material being ground will generally create substantially greater amount of air borne particles.
Hazardous Polymerization: Will not occur
Conditions to avoid: **N/A
Section VI - Health Hazard Data
Primary Route(s) of Entry
Acute and Chronic Health Effects and Effects of Overexposure
First Aid and
Medical Information
Inhalation (while grinding)
Acute: May cause coughing, shortness of breath (dust). Chronic: May effect breathing capacity.
Remove to fresh air. Apply artificial respiration as needed. Obtain first aid or medical assistance.
Ingestion
No known adverse affects, but ingestion not recommended.
Obtain first aid or medical assistance.
Skin (contact & absorption)
Not absorbed through skin; may cause abrasions.
Obtain first aid or medical assistance.
Eye
Dust may irritate eyes.
Wash with large amounts of water. Obtain first aid or medical assistance.
Other Potential
Health Risks
On some grinding, elevated sound levels may be created which could affect hearing.
Obtain medical assistance.
Carcinogenicity: Not known
Section VII - Precautions For Safe Handling And Use Steps to be taken in case material is released or spilled: Normal clean up procedure.
Waste disposal method: Standard landfill methods consistent with applicable Federal, State and Local laws.
Precautions to be taken in handling and storage: During storage, occasionally a formaldehyde or phenolic resin odor may be released.
Other Precautions: **N/A
Section VIII - Control Measures Respiratory protection (specify type): As needed, approved dust respiratory (OSHA 24 CFR 1910.134)
Ventilation:
Local Exhaust: Required
Mechanical (General): Recommended
Special: **N/A
Other: **N/A
Protective gloves: Recommended
Eye protection: Recommended OSHA 29 CFR 1910.133 (Face & Eye Protection)
Other protective clothing or equipment: Hearing protection; safety glasses & protective clothing must be worn when operating abrasive products.
Work/Hygienic Practices: **N/A
* Materials are regulated by OSHA 29 CFR 1910.1200 (Hazard Communication Standard).
